|
Battery Repair Service - Check or
Replace Checked With Your Routine Vehicle Maintenance
|

|
|
For Your Convenience,
Please Print This Page >>
|
|


Swis Tire and Auto Locations and Contact Form
Find The Battery For Your Car Or Truck
Question:
I need a new car battery, what will I need to do with the old one?
If your car battery has already served its purpose and now needs to be replaced, go ahead and do
so. Buy a new battery and replace the old one. You surely would need a battery for you to go places with your
car.
First off, you do buy the kind of battery that the auto maker who crafted and designed your vehicle
recommends. It is easy to find the right battery for it is just like purchasing Volvo V40 car parts for your Volvo.
If you do not know what this kind of battery is, try to check your car owner’s manual. Or if not, you can always
run to auto experts like Swis Tire and Auto for additional information.
Keep in mind, though, that for purposes of recycling, the old one must be exchanged with the new
one you will buy.
So if you would be doing the replacing yourself, you can just drop off the old one at a later time,
after you have installed the new car battery.
Now it is time to open the hood and find where your battery is. Once you have found the old
battery, disconnect the cables from the terminals of the battery. Keep in mind that you should find the negative
cables first before you proceed to disconnecting the positive cables.
Negative cables are colored black while the red ones are the positive cables. And when you have
successfully done so, remove the frame that holds the battery in place and take the battery out.
Before you put in the new car battery, make sure that the cable terminals are clean. You can use a
wire brush and some baking soda with water to clean them off if they are already dirty or are already corroded.
Clean the battery terminal also.
If they are already damaged and beyond using, now would be the right time to replace them.
When everything is already clean, you can now put the new battery in the frame. Then attach and
connect the cables. This time, attach the positive cables first, and then proceed to the negative cables. And when
you have done so, you can now test your battery if it has been connected properly. If everything has been properly
installed, your engine should start easily.
Need Help With a New Battery? Contact Us Today!
|